Shop tools · Free · Full-scale print
Round Tube Notcher
Lay out a fishmouth that actually sits down. Put in the header (parent) and branch (cut) sizes, the wall, and the angle between them. You get a wrap-around template you can print at 100%, plus plot offsets for pipe too big to wrap paper around. Using the PSG slider tool? You also get the depth to set each slider to.
Wall thickness above zero fits the cut to the branch's inside diameter, which leaves you a weld groove on the outside. Set the wall to 0 if you want a tight outside fit and plan to back-grind the inside.
Joint setup
Joint profile
Wrap-around template (true scale)
Full set of templates
Draws a separate template at each angle for the current tube sizes and wall. Prints one per page.
Save, share & screen scale
Saved setups (kept in this browser)
Match the screen to a ruler
Only if you want to measure straight off the monitor. Printing always comes out at true size. Drag until the bar below measures exactly 4 inches.
Using the template
Wrap and mark
- Print at 100% / actual size. Turn off "fit to page". Check the 1/2" scale square and the circumference with a tape before you cut anything.
- Trim along the square bottom edge and the two side edges. Leave the curve for now.
- Wrap it around the cut tube so the two side edges just meet. Keep the square edge on a square line around the tube.
- Line up the dashed centerline with the acute (inside) side of the joint. That's the deepest part of the notch.
- Trace the curve with a fine marker or soapstone, then saw, torch or grind to the line and dress it on the parent.
PSG slider tool
- Enter the sizes, wall and angle. Leave Slider tool settings on.
- Set each slider to its depth from the slider table. Sliders with the same number on each side of center get the same setting.
- Put the tool on the cut tube with the center slider on the acute side, trace around the end of the tool, and cut to the line.
- Print slider settings gives you just the table to take to the saw.
Big pipe: plot offsets
- Pick Plot offsets and a station spacing.
- Square a line around the pipe at the end. Then mark stations around the circumference, starting at the centerline (the acute side).
- At each station, measure back from the square end by the listed offset. Both sides are the same, so the table covers center to the back.
- Join the marks with a batten or a strip of flat bar and cut.
Printing tips
- The page fit line under the template tells you the smallest sheet it fits on. If it won't fit, try Half, poster-print over several sheets and tape them together, or use Plot.
- Print template only leaves off the profile and summary so the template lands at the top-left of the page.
- Download SVG gives you a true-scale vector for a plotter, plasma table or CAD.
- The math here is geometry only. Allow for kerf and weld prep the way you normally would.